Liquid-Resistant Limit Switch - 3mm/4mm/.188" Height


Global Thinswitch Limit Switch helps prevent accidental mold close in injection molds by verifying ejector plate return in injection molds with 3mm, 4mm or 3/16" rest buttons, and where occasional water or oil spray is present. A polyurethane dome covers the actuator spring, protecting internal gold switch contacts from environmental contamination.

A special mounting bracket aids installation from the edge of the mold. The bracket allows molders to slide the Thinswitch into place without disassembling the mold or using screws to hold the switch in place.

Features and Benefits

  • Over 14 million cycle life
  • 176°F (80°C) standard temperature rating
  • CE Marked, housing rated IP 41
  • Adjustable actuation between 3.2mm and 4mm from the switch base (excludes spacer)
  • 3mm thick design fits snugly behind the ejector plate between the rest buttons of European Standard Molds
  • Stripped and tinned 2M wire leads
  • SPST switch action
  • Mounting screws and wire clips included
  • Special mounting bracket allows slide-in switch removal; protects cable from damage between mold changes.

Click Here to Download In-Mold Sensors Catalog

Click Here to Download In-Mold Sensors Catalog (Spanish)

Click Here to Download Instructions