FASTIE® - Quick Ejector Tie-In System
FasTie Quick Ejector Tie-In System quickly "ties-in"
the mold ejector plate to the press ejection system in an injection molding press, dramatically reducing mold change
time. The greatest time savings are realized in presses where space is limited and the ejector system is difficult to tie
in using solid knock-out bars.
The FasTie coupler is permanently mounted to the press ejector plate. The quick-connect locking mechanism in the
coupler snaps mechanically onto the mold-mounted stud during mold installation.
To release the ejectors, apply shop air to the coupler. The coupler opens to release the stud, disconnecting the press and tooling
ejector plates. The coupler remains in the open position, ready for a new mold to be set.
For multiple ejector locations, an air manifold is recommended to release all couplers simultaneously.
Two FasTie sizes are available: 1-inch model for presses 500 tons and under, and 2-inch model for presses larger than 500 tons.
Additional installation examples and accessories lists are located in the catalog. Download the .pdf file below. |
SPEEDBAR® - Adjustable Knock-Out Bar
(SPEEDBAR® shown with FASTIE®
Coupler attached)
|
SpeedBar is an adjustable length knock-out bar that
can quickly compensate for variations in different molds. Used with the
FasTie system, mold ejector plate tie-in and adjustment times are reduced to
seconds. The adjustment sleeve is easily rotated to change the bar length
up to 1-inch in increments of .006". Once the desired length is set, the
spring-loaded sleeve securely locks in your adjustment.
Fixed length knock-out bars are blank on one end for
on-site finishing. Longer bars are available. |
Fastie Patent No. 6,379,072
SpeedBar Patent No. 6,315,544
Features and Benefits
- Faster Mold Changes
- Various Thread Sizes Available
- Flexible Modular Installation
- No Mold Modifications Required
- Reduced Wear, parts stay connected during molding cycles
- Hardened Steel Materials
|
|
